رفتن به محتوای اصلی
ارسالات ترکیه: ۸ تا ۱۲ روز کاری

آداپتور کلید برق 19mm برای Voron 2.4

Voron 2.4 Front Skirt 19mm Power Switch Adapter

طراح: geoffsim

قیمت فایل با خرید و تحویل

۱٬۲۵۹٬۰۰۰ تومان

قیمت ارزی فایل
۳.۶ EUR
معادل تومانی
۱٬۰۵۹٬۰۰۰ تومان
کارمزد خرید
۲۰۰٬۰۰۰ تومان

بعد از پرداخت، فایل را برایتان می‌خریم و در صفحهٔ همین سفارش در حساب شما برای دانلود می‌گذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یک‌بار گرفته شود.

مجوز: PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپ‌شده مجاز نیست

این طرح کار طراح آن است و مجوز استفاده‌اش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.

دربارهٔ این مدل

I found it hard to reach behind my 300mm Voron 2.4 to turn the power on/off, so I looked for a front panel power solution. Whilst there are modified skirts, these take an age to print. I found an insert that allowed the fitting of a low power round switch, but I wanted a mains switch so I created an insert for the common round 19mm mains push switch. The result is an adapter that is easy to print; easy to fit; and prints in about fifteen minutes. The insert will properly fit only in the upper honeycomb holes. Fit the adapter with the slot to the top (follows the curve of the skirt). Remove the rubber seal from the switch before fitting to allow the switch to fit flush to the adapter. Remove the skirt from the printer before installing the switch if it makes it easier to fit and wire up. Note that all my designs have gone through an iterative process to ensure that the item fits accurately and is easy to print. If you like this, please consider a donation. -

  • voron
  • power
  • adapter
آداپتور کلید برق 19mm برای Voron 2.4 (Voron 2.4 Front Skirt 19mm Power Switch Adapter) — فایل پرینتر سه‌بعدی (STL)