رفتن به محتوای اصلی
ارسالات ترکیه: ۸ تا ۱۲ روز کاری

پایه نگهدارنده خودرو iPhone 5/5S/SE

iphone 5/5S/SE car mount

طراح: ZAMO3DPRINT

قیمت فایل با خرید و تحویل

۹۳۵٬۰۰۰ تومان

قیمت ارزی فایل
۲.۵ EUR
معادل تومانی
۷۳۵٬۰۰۰ تومان
کارمزد خرید
۲۰۰٬۰۰۰ تومان

بعد از پرداخت، فایل را برایتان می‌خریم و در صفحهٔ همین سفارش در حساب شما برای دانلود می‌گذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یک‌بار گرفته شود.

مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپ‌شده مجاز نیست

این طرح کار طراح آن است و مجوز استفاده‌اش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.

دربارهٔ این مدل

Car mount (ventilation fins) for iPhone 5/5S/SE with passage for jack and ligthning port. The holder is designed for phones without shells. Simply glued two-piece assembly. Approx. 1 hour 45 min. printing time. The iphone slips in and out without forcing and is perfectly held in place. TIP FOR PLA PRINTS: gradually subject the fixture to a temperature of 80°C for 15 minutes. After this, the PLA will be able to withstand a temperature of around 110°C. This is very important, as it will be attached to your car's heater grilles. printing with 0.20mm layers and in "filled" mode, with supports starting from the plate.

  • iphone
  • voiture
  • support
  • simple
پایه نگهدارنده خودرو iPhone 5/5S/SE (iphone 5/5S/SE car mount) — فایل پرینتر سه‌بعدی (STL)