جیگ خمکاری فنر
Spring Bending Jig
طراح: qfrederick
قیمت فایل با خرید و تحویل
۳۴۷٬۰۰۰ تومان
- قیمت ارزی فایل
- ۰.۵ EUR
- معادل تومانی
- ۱۴۷٬۰۰۰ تومان
- کارمزد خرید
- ۲۰۰٬۰۰۰ تومان
بعد از پرداخت، فایل را برایتان میخریم و در صفحهٔ همین سفارش در حساب شما برای دانلود میگذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یکبار گرفته شود.
مجوز: PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپشده مجاز نیست
این طرح کار طراح آن است و مجوز استفادهاش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.
دربارهٔ این مدل
Springs aren’t exactly expensive, but if you need one of a specific size, they can be. Fortunately, making them from music wire isn’t conceptually difficult. The hard part is consistently bending the wire in the right places and the right directions. That’s what a jig is for. This design allows one to bend a compression spring efficiently and consistently. The bend angle and wire segment length are both adjustable. It can make square or rectangular springs (or any polygonal profile, technically), with minimum wire segment length of about ¾”. I guess wire segment length is not limited, but past about 3 or four inches, this jig won’t really help much. There is no real limit on spring length. Since each type of wire varies slightly in yield limit, elasticity, stiffness, etc., one will need to test one’s wire to find out how far to push each bend. This design is sized for 1.4mm (0.055”) music wire, but could probably handle anything that doesn’t differ from it in diameter by more than a few hundredths of an inch. The corners of any spring made with this jig will be rounded, with a radius of about 1/4”. Printing with the recommended settings requires 26 grams of filament, and use requires some sort of clamp and a pair of pliers. Also, a 40 mm long M4 bolt and threaded insert are required, unless you skip the alignment post, in which case you’ll need the bolt and a M4 nut. https://youtu.be/cebWEIVz3EY Another design or two you may appreciate: [creation binder-clip-bear-trap-improved] [creation improved-conibear-trap] Or, if your application requires a stronger spring than 0.055" wire can comprise (or a compression spring wouldn't be suitable), I wouldn't miss a chance to endorse my favorite piece of office equipment: [creation binder-clip-tension-spring-adaptor] [creation binder-clip-bending-spring-adaptor] Instructions for printing and use are included in the guide document.
- wire
- wire bending
- spring
- diy
- customize
- helical spring
- spring steel
- music wire
- spring factory
- spring bending
- custom spring
- metalworking