پایه نگهدارنده MagSafe آیفون Polestar 2
Polestar 2 iPhone MagSafe mount
طراح: bjornalarssson
قیمت فایل با خرید و تحویل
۱٬۲۶۲٬۰۰۰ تومان
- قیمت ارزی فایل
- ۳.۶۱ EUR
- معادل تومانی
- ۱٬۰۶۲٬۰۰۰ تومان
- کارمزد خرید
- ۲۰۰٬۰۰۰ تومان
بعد از پرداخت، فایل را برایتان میخریم و در صفحهٔ همین سفارش در حساب شما برای دانلود میگذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یکبار گرفته شود.
مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپشده مجاز نیست
این طرح کار طراح آن است و مجوز استفادهاش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.
دربارهٔ این مدل
This is a phone mount for iPhone 12, 13 and 14. It uses an Apple MagSafe charger (with usb C). It prints in two parts that are later glued together. Takes about 1,45hr + 2 hrs to print both A and B parts. ((I'd recommend using the V3 A + B in your Left Hand Drive / Right Hand Drive)) The mount itself attaches to the top of the display with double sided tape (don't use foam tape cause that is usually harder to get off if needed). I use Tesa Outdoor. The MagSafe charger will press fit and sit snuggly, without tape or glue. Could be printed in PLA if used in colder climate/ winter. PETG is better if used in warmer climate/ hot summer. Tested during winter in PLA & PETG. The Apple MagSafe version is 0.3mm larger in diameter then the charger itself, but should fit snuggly. The depth is 4mm. There is also a Belkin version that has a larger diameter 60.3mm (the design is 60.6mm but should fit tight) and 5mm deep cutout. This is V1.5. You need both the A and B-part. The "P2MS A main part" fits both All Belkin + the Apple Square version. Send an message is you have suggestions for different sizes/versions. 15 jan 2023: Also available as Right Hand Drive, RHD. 24 feb 2023: Added a version for driver side (D1 + D2). 27 apr 2023: Added RHD for V3 as well as a solid V3 for using with a magnet mounting plate and ALL PHONES (more info on this later). 3 jun 2023: Added a V3 LHD that prints in one piece. There is also a version that is -4 mm just if it gets tight on the print bed. 19 sep 2023: Added a V3 A DUAL mount to hold TWO iPhones. Combine this A-file with V3 B LHD and V3 B RHD. Demo video on V1 here: https://youtu.be/Np8PedwYTDg And V2 V3 here: https://youtu.be/0fdLwg3V2b0 0.2mm, supports on both parts.
- polestar 2
- phone mount
- phone holder
- iphone
- magsafe
- p2ms