رفتن به محتوای اصلی
ارسالات ترکیه: ۸ تا ۱۲ روز کاری

داک کریستالی Nintendo Switch مدل Classic و OLED

Nintendo Switch Crystal Dock - Classic and OLED version

طراح: Holoprops

قیمت فایل با خرید و تحویل

۲٬۶۰۷٬۰۰۰ تومان

قیمت ارزی فایل
۷.۶۴ EUR
معادل تومانی
۲٬۲۴۷٬۰۰۰ تومان
کارمزد خرید
۳۶۰٬۰۰۰ تومان

بعد از پرداخت، فایل را برایتان می‌خریم و در صفحهٔ همین سفارش در حساب شما برای دانلود می‌گذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یک‌بار گرفته شود.

مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپ‌شده مجاز نیست

این طرح کار طراح آن است و مجوز استفاده‌اش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.

دربارهٔ این مدل

**Print-in-place No Support Needed** **Both Switch OLED AND Switch CLASSIC versions are included.** Do you want a fantastic way to customize your Switch Dock? Here's the Nintendo Switch Crystal Dock Decor! Super easy to print in any color to go along with your TV setup! The model was carefully designed not to obstruct the AirFlow of the Switch or the cables at the back. Note that the USB ports will be covered, though. The two crystal parts snap and stay put together nicely! ⭐⭐⭐⭐⭐ IMPORTANT NOTE: If you want to sell 3D prints based on my designs **legally**, please become a supporter on the Thangs Membership: 🔵[Thangs - Membership](http://tinyurl.com/Holoprops) All of my Designs are covered by a Creative Commons Non-Commercial License. Sale of prints using my designs are the sole right of myself, the designer, and my active Patreons to do so. Please understand every design is days of work and multiple prototype prints to ensure quality. Happy printing! FIX (Dec2022): Reuploaded Part B * Minor transformations to realign some crystals that could disturb the docking. * Consolidate one area that was a weak spot To get the best out of the STL file, please follow these guidelines: • **No support is needed for any parts. Everything is Print-in-Place.** • Layer Height 0.2mm • Nozzle 0.4mm • Recommended infill 15%. • Recommended Infill Pattern: Gyroid or Cubic • Prepare and clean your bed for excellent adhesion. • Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results. • Make sure your bed is correctly leveled. Then check again :D • Try to hide the seam and place it where nobody will pay attention. • Make sure your printing and bed temperatures are adequate for the filament you are about to use.

  • dock
  • switch
  • nintendo
  • joycon
  • mario
  • zelda
  • crystals
  • decoration
  • gaming
  • setup
  • gamer
  • pokemon
  • controller