کیت فن 5015 برای Magna SE، 2 و Wanhao D12
Magna SE / 2 / Wanhao D12 - Fan kit 5015
طراح: Nikairos
قیمت فایل با خرید و تحویل
۷۸۸٬۰۰۰ تومان
- قیمت ارزی فایل
- ۲ EUR
- معادل تومانی
- ۵۸۸٬۰۰۰ تومان
- کارمزد خرید
- ۲۰۰٬۰۰۰ تومان
بعد از پرداخت، فایل را برایتان میخریم و در صفحهٔ همین سفارش در حساب شما برای دانلود میگذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یکبار گرفته شود.
مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپشده مجاز نیست
این طرح کار طراح آن است و مجوز استفادهاش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.
دربارهٔ این مدل
Kit to mount a 5015 fan in place of the stock fan, considerably increasing airflow and therefore overhangs. Only the plastic housing and nozzle need to be replaced by printing, then replaced using the same screws. Additional materials required: -Fan 5015 24v -2 screws of approx. 3mm diameter (any one) COMPATIBLE WITH MAGNA SE (8-32-PRO) and Wanhao D12 ATTENTION: For magna SE 8 bits, we do not have the plastic terminal block, so the replacement of the fan is done by disassembling part of the hotend and soldering. Operate at your own risk! __________________________ Kit to mount a 5015 fan instead of the stock fan, considerably increasing the air flow and consequently the overhangs. Only print the plastic housing and the duct must be replaced, then it is replaced using the same screws. Additional materials needed: -Fan 5015 24v -2 screws with diameter approx. 3mm (any) MAGNA SE (8-32-PRO) - Wanhao D12 COMPATIBLE To print the case: Print with the face with the large circle, flattened against the bed. Layer height 0.24 is sufficient To print the nozzle: Use balsa + arbor support, with the exit resting against the bed. I recommend 0.16 resolution or better. In Pla is sufficient, but I recommend PETG for durability. For the LIGHT version I recommend PETG/ABS, as the wall thickness is lower.
- magna
- to
- magna 2
- 5015
- wanhao d12
- fan
- mount
- stock
- box
- housing
- 3d enhancements