رایزر CANVAS برای Centauri Carbon 1
Centauri Carbon 1 Riser for CANVAS
طراح: youraverageprinter
قیمت فایل با خرید و تحویل
۱٬۱۳۸٬۰۰۰ تومان
- قیمت ارزی فایل
- ۳.۱۹ EUR
- معادل تومانی
- ۹۳۸٬۰۰۰ تومان
- کارمزد خرید
- ۲۰۰٬۰۰۰ تومان
بعد از پرداخت، فایل را برایتان میخریم و در صفحهٔ همین سفارش در حساب شما برای دانلود میگذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یکبار گرفته شود.
مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپشده مجاز نیست
این طرح کار طراح آن است و مجوز استفادهاش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.
دربارهٔ این مدل
****Latest updated files are all labelled as "V3_*Part name*"**** The updates include a side hood like the original CC2, taller pillars with wider bases for better plate adhesion, and taller front/back and left side panel. All the original files are still included for those who want to modify the existing setup. **I've also added hollow left side and front/back, so you can add pieces of plexiglass or hardboard (182x160mm), this brings the total print to less than 1kg!** Here is a set of files for a riser to allow the CC1 to have the CANVAS system with stock glass lid (also fits Jesus Freak's vented riser on top) . I personally have routed the USB cable vertically, and cable tied it to the PTFE tubes. It has been running great so far. There are 4 pillars, each have clips for LED ribbon, and the back pillars have slots to run the LED wiring through the back. The left side panel can be printed twice if you're not using Canvas, or you can print 1 left side and 1 right side with cutout for Canvas (the original files have 4 threaded ports for PTFE tube push-connectors...if anything in the files doesn't line up, I will modify and update as I can) The vent covers are printed 3 (or 4) times, depending on your layout. The magnets are 10mm x 2mm, you can get them in bulk on amazon for under $25 a pack. Make sure you align the polarity all the same! Otherwise your vent covers will not be happy :) You will need 24 pins, and it would be best to print all your walls first, then print 1 pin and test the fitment. Scale it as needed. The goal is to have a tight fit so it doesn't fall apart, but you could always change the sides if you decide to go with Canvas. You can also superglue it all together, your call! If you go with Canvas, I have allowed a bit of space to add weatherstripping if you feel it's necessary. Thanks for your support! 0.2mm layer height, 3 walls, 5-15% infill, tree supports only on canvas side.