رفتن به محتوای اصلی
ارسالات ترکیه: ۸ تا ۱۲ روز کاری

قطعه تعمیر محفظه داشبورد Alfa Romeo Giulietta

Alfa Romeo Giulietta Dashboard Storage/Lid Repair

طراح: Wesstphal

قیمت فایل با خرید و تحویل

۴۱۸٬۰۰۰ تومان

قیمت ارزی فایل
۰.۷۴ EUR
معادل تومانی
۲۱۸٬۰۰۰ تومان
کارمزد خرید
۲۰۰٬۰۰۰ تومان

بعد از پرداخت، فایل را برایتان می‌خریم و در صفحهٔ همین سفارش در حساب شما برای دانلود می‌گذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یک‌بار گرفته شود.

مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپ‌شده مجاز نیست

این طرح کار طراح آن است و مجوز استفاده‌اش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.

دربارهٔ این مدل

Is the folding compartment on your AR Giulietta not working? There are several possibilities for what could be broken with this storage, but if you have this specific problem, like me -- https://youtu.be/L9O3ZedK270 it can be fixed using 3D printing and strong glue. -- Lid mount -- • Broken plastic must be completely broken off and thrown away, see photo. • Then attach the printed part in its place • Fit the lid into it (it takes a little force, push the gray latches of the roller into place) • Place it so that everything sits straight, make a groove in the base where the printed part should sit • Remove the lid again • Clean and possibly roughen the printed part with sandpaper, as well as the base where you will glue it. • Glue it with strong plastic glue. • Let it harden. • Finally, put everything together • Put the spring in place - you need enough force to push the spring into the designated place. (I also secured the spring with a printed stopper so that it doesn't come off, but this will make it more difficult to disassemble next time) (When opening the lid, the upper part of the spring rests against the wall, so that it is not so hard, I taped this place with soft material, see photo) -- Lid latch -- Carefully cut off the remains of the original latch and sand it smooth with sandpaper. First attach the printed part with double-sided tape (something temporary) and test whether it fits where it should. If so, roughen it up with sandpaper and glue it in the right place and let it harden. I used ABS as the material. You need a strong material that can withstand higher temperatures and the print is strong, but at the same time reacts with the glue. For the "Lid mount" part, you need to use supports. After printing this part, test how well the metal rod fits into the hole, or sand it with sandpaper,

  • alfa romeo
  • giulietta
  • storage
  • lid
  • dashboard
  • repair
قطعه تعمیر محفظه داشبورد Alfa Romeo Giulietta (Alfa Romeo Giulietta Dashboard Storage/Lid Repair) — فایل پرینتر سه‌بعدی (STL)