Aizawa Shouta "Eraser Head" Goggles
طراح: Bnackus
قیمت فایل با خرید و تحویل
۱٬۵۴۹٬۰۰۰ تومان
- قیمت ارزی فایل
- ۴.۵۴ EUR
- معادل تومانی
- ۱٬۳۳۵٬۰۰۰ تومان
- کارمزد خرید
- ۲۱۴٬۰۰۰ تومان
بعد از پرداخت، فایل را برایتان میخریم و در صفحهٔ همین سفارش در حساب شما برای دانلود میگذاریم. چند فایل را با هم در سبد بخرید تا کارمزد یکبار گرفته شود.
مجوز: CULTS PU - Private Use — فقط استفادهٔ شخصی؛ فروش محصول چاپشده مجاز نیست
این طرح کار طراح آن است و مجوز استفادهاش همان مجوز طراح است؛ پخش یا فروش خود فایل مجاز نیست.
دربارهٔ این مدل
Eraser Head's goggles from My Hero Academia. uses paperclips as pins to hold all the pieces together in a chain. a dab of clear glue holds the pins in place. the "lenses" are also printed, you can see out of them just fine but no one can see in. lenses stay in place with a small amount of glue in the corners. it's possible to print this and not have to paint it if you use yellow and black filament. PARTS LIST left eye piece X1 right eye piece x 1 nose piece X 1 lens small X 2 lens long X 2 left chain end X 1 right chain end X 1 left chain link X 3~6 right chain link X 3~6 Paper Clips or Stiff Wire Clear Glue Elastic strap and a needle and thread or velcro LAYER HEIGHT I printed these at 0.2 mm layer height. you can use a finer setting, but I would not use a courser setting as the sizing and quality of the pinholes may decrease. SHELLS 2 outer walls is perfectly acceptable for most parts. on the lenses i used 4 walls for better bed adhesion. the lenses should also have 0 top and bottom thickness so you can look throught the infill. some slicers are easier to do this on than others. SUPPORTS most parts are set up to need the least ammount of supports, but most parts still require them. the chain links absoutley need supports for the floating pin holes. they should be easy to clean up if the bottoms of the holes are not perfect. the eye pieces have areas that may need supports, but if you can do good bridhes and overhangs you may not need them. the nose piece does not require supports. the lenses do not require suppors. PRINT ORIENTATION all parts should be pre-oriented for best printing. ASSEMBLY use paper clips or other wire to attach all the pieces. push the wire through the pin holes to attach each piece in series. and snip them so they are flush with the printed part. put a small dab of glue into the hole at both ends to secure the pins in place. the chain ends should go at the end of the chain, and have a loop to attach and elastic or velcro strap.
- cosplay
- my hero academia
- boku no hero academia
- eraser head
- aizawa shouta